Are there specific requirements for fire pump room design?

Yes, various regulations and standards, such as those set forth by organizations like the National Fire Protection Association (NFPA), govern the design, installation, testing, and maintenance of firefighting pumps to ensure their safety and effectiveness. Compliance with these standards is essential for maintaining fire safety standards and regulatory requirements.

Outdoor controller for fire pump set use for outdoor fire pump set

The fire pump set consists of electric pump + diesel pump + jockey pump, The pressure switch and control cabinet can automatically turn on/off three pumps-the electric pump and jockey pump operate when there is electricity and the diesel pump activates when the power cuts.

What are the components of the fire pump group
1. Electric pumps: various end suction pumps and split case pump.
2. Jockey pump: vertical, small flow, head higher than electric pump or diesel pump.
3. Control panel: Automatically control the water pump, with overload and overcurrent protection functions.
4. Accessories: suction pipe, discharge pipe with flange, battery, gate valve, check valve, expansion joint, pressure switch, pressure gauge, base, etc.

Floating impeller axial force tone- balancing device
The balancing slice device has two gaps, the radial gap behind the impeller and the axial gap of the balancing slice, because of these two gaps, the balancing slice can automatically acclimate the axial l gap to achieve automatic balance of axial force, and the tableware rotor is in a floating state.

The principle of the balance plate is scattered to the impeller, the impeller back mouth ring radial concurrence below the axial concurrence, this device that’s the same as the balance plate, the conformation of two gaps, only in a different position. Because the impeller has these two gaps to round each other, so that the impeller can also achieve automatic balance of axial forces.

The lifespan of a fire pump depends on factors like maintenance, usage, and environmental conditions. With proper maintenance, fire pumps can last for several decades.

An anechoic check valve, control valve and pressure gauge should be installed on the discharge pipe of the fire pump; a pressure gauge and pressure switch should also be installed on the total discharge pipe of the system; a buffer device should be added when installing the pressure gauge. A cork should be installed between the pressure gauge and the buffer device; the pressure gauge range should be 2 times to 2.5 times the working pressure of the system when there is no design requirement.

Flow: 30-9000GPM
Head: 3-20Bar
Speed: 740-2900r/min
Frequency: 50 HZ or 60 HZ
The ED Dual-Power Fire Pump System combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply. In the event of power outages or electrical failures, the diesel engine pump seamlessly takes over, guaranteeing continuous operation of the fire protection system. This dual-power configuration offers both reliability and flexibility, providing comprehensive coverage for fire safety needs.

1. The biggest feature of the complete fire pump set is its strong reliability. Even if it is restarted for a long time, it will not bite to death, and it can be restarted normally.
2. The use efficiency is very high. During the use process, there will not be too much noise. The installation form of the fire pump set is very flexible, and it is convenient for maintenance, which can effectively save installation and maintenance costs.??

After receiving the fire/pipe network pressure/power failure/other start signals, the diesel engine fire pump can automatically start and enter full load operation within 5 seconds. The battery can be automatically charged by the main power supply or the diesel charging motor to ensure the smooth start of the equipment; automatic alarm protection for low oil pressure, high water temperature and other faults of the diesel engine, overspeed alarm and shutdown; the diesel engine fire pump is in a hot engine standby state to ensure emergency work. The diesel engine fire pump adopts the direct connection technology between the diesel engine and the water pump. Through the elastic coupling, the failure points are reduced, the start-up time of the unit is greatly shortened, and the reliability and emergency performance of the unit are improved.

3 sets 100gpm 7bar EDJ fire pump set

EEJ Fire Pump Set means 2 electric pumps and 1 Jockey pump. The rated pressure is less than 150m. The speed is 2950 to 3550 RPM.

EDJ series fire pump set consists of electric pump + diesel pump + jockey pump and all accessories.

The EEJ Fire Pump System is an innovative solution designed to enhance fire safety in various settings. With exceptional performance and efficiency, the EEJ Fire Pump System delivers high pressure and large flow capacity, enabling rapid and effective fire suppression. Its intelligent features, including real-time monitoring and remote control capabilities, contribute to the system’s reliability and ease of operation. Overall, the EEJ Fire Pump System is a reliable choice for safeguarding lives and properties, making it an ideal fire protection solution for commercial buildings, industrial facilities, and residential areas.

Fire pumps are an important part of the fire protection system, especially in high rise structures.In basic 400 – 500 or advanced water situations, fire pumps are important to distribute water into water lines and sprinkler systems where the water pressure of the fire fighting equipment cannot reach. Especially in low-rise structures, fire pumps are important for fire control.
Stylistically, fire protection is a dangerous activity, but without a well-designed and professionally installed system and pump, it certainly becomes more dangerous and commercial assets and lives are less at risk.

EDJ fire pump set is composed of electric pump + diesel engine pump + jockey pump. The fire pump set has the characteristics of high efficiency and energy saving, reliable quality, strong overload capacity, compact structure, convenient maintenance and high degree of automation. Suitable for any emergency firefighting occasion.

The minimum fire rated pressure of ED small fire fighting package set water supply equipment is 3 bar and the minimum fire rated capacity is 25 GPM. ED small fire fighting package set water supply equipment includes at least two power or power source driven pumping unitspressure tanks,pipesvalves and accessories measurement and control instruments,control cabinetsoutdoor rain coveretc.

The fire pump unit is composed of a fire water pump, a double shaft extension motor and a diesel engine. One end of the output shaft of the double shaft extension motor is connected to the input shaft of the fire water pump, and the other end of the output shaft of the double shaft extension motor is connected to a One end of the clutch is connected, and the other end of the clutch is connected with the output shaft of the diesel engine. The fire water pump, the double-shaft extension motor, the clutch and the diesel engine are all fixed on the base. The double shaft extension motor, the clutch and the diesel engine are respectively electrically connected with a control circuit through an action drive circuit. With dual-power fire pumps, there is no need to configure a second fire pump, which reduces floor space and saves manufacturing costs.

EJ fire pump is composed of electric pump + jockey pump
Those pictures display OTS series electric motor pump. OTS double suction split-case centrifugal pump has a wide range of performance, with the ability for a variety of uses.

Fire pumps can be powered by various sources, including electricity, diesel engines, and, in some cases, natural gas. The selection of a power source depends on factors such as reliability, availability, and the specific requirements of the facility.

Electric fire pumps are commonly used in urban areas with a stable power supply. They are efficient and can start automatically in response to a fire alarm signal. In contrast, diesel-powered fire pumps are reliable in areas with inconsistent power availability, as they can function independently. The choice of power source should align with the facility’s operational conditions and the need for uninterrupted fire protection.

Signs include unusual noises or vibrations, reduced water pressure or flow, frequent tripping of the pump, leakage, and failure to start. Regular inspections and testing can help identify issues before they become critical.

Flow: 30-9000 GPM
Head: 3-20Bar
Speed: 740-2900r/min
Material: HT200, SS304, Bronze

The EJ Fire Pump Set is combined an electric pump and a jockey pump.In various fields, our products find applications in large hotels, hospitals, schools, office buildings, supermarkets, commercial residences, subway stations, train stations, airports, various transportation tunnels, petrochemical plants, thermal power plants,oil storage tanks, large warehouses, industrial and mining enterprises, seawater injection, etc.

The motor of this fire pump set is directly connected to the fire pump, which simplifies the intermediate transmission structure and enhances the stability of operation. The equipment occupies a small area, saves costs, and is a cost-effective fire pump set.

EJ fire pump set producting
150gpm 7bar electric fire pump with jockey pump
Assemble in our workshop

Zhejiang Better Technology Group Co., Ltd. mainly produces various industrial pumps, electric motor fire pumps, diesel engine fire pumps, fire-fighting special water supply equipment, fire-fighting dual-power water supply equipment, general-purpose fire-fighting gas top pressure water supply equipment, fire pump control cabinets, fire-fighting frequency conversion automatic Inspection cabinets, fire protection dual power supply cabinets, submersible sewage pumps, pipeline pumps, chemical pumps, oil pumps, slurry pumps, vacuum pumps and complete sets of vacuum equipment, non-negative pressure water supply equipment, frequency conversion constant pressure water supply equipment and water tanks of various materials, fire protection, Domestic pump room control cabinets, etc., products are widely used in agriculture, machinery, chemical industry, papermaking, medicine, food, sugar, electronics, metallurgy, ceramics, water diversion, printing and dyeing, building materials and other fields.

The EEJ fire pump set is composed of two electric pumps + one jockey pump. The motor of the electric pump is directly connected to the ISW pump head. The jockey pump adopts CDL pump, adopts high-quality NSK bearing and wear-resistant mechanical seal, which is suitable for any emergency firefighting occasion. . Products can be customized according to their own needs.

The EJ Dual Power Fire Pump System is an innovative and reliable fire protection solution. Combining an electric pump for robust water pressure and flow with a top-quality jockey pump for stable pressure maintenance, this system ensures efficient and timely water supply during fires. With advanced automation, remote monitoring, and energy-saving features, the EJ Dual Power Fire Pump System is a trusted choice for commercial, industrial, and residential applications.

Diesel engine-driven fire pumps are designed and manufactured in accordance with GB “Fire Pumps”. Comply with CCCF certification requirements. The advantage of its product is that when a fire occurs, the power supply fails, and the electric fire pump group cannot be put into use normally, the diesel engine fire pump group can be automatically put into operation to ensure the normal fire fighting. Compared with the electric fire pump set, the second advantage is that it does not need long-term investment in power supply, saving the mains power supply transformer and normal expenses. Diesel engine fire pumps are equipped with various automatic functions to meet customer requirements, ensure long-term normal standby status of the equipment, and put it into fire fighting work at any time. The diesel engine fire pump set is also suitable for various emergency backup pump occasions.

·UL Standard
Flow：50-3000 GPM
Head： 5-20 Bar (72.5-290 psi)
Speed：740-2900 r/min
·Non-UL Standard
Flow：30-9000 GPM
Head： 3-20 Bar (40-300 psi)
Speed：740-2900 r/min

Small fire pump set—With small flow, small lift and diesel electric matching, it is suitable for small buildings, small in size, small in floor area, and can save a lot of space and installation. It is the first choice of many foreign customers.Better Technology Group is committed to the production, testing, packaging, delivery and technical development of fire pumps. It researches pump products in many aspects and brings high-quality and high-performance fire pump products to many countries.