DJ Diesel Engine Fire Pump Being Packed

Assess existing capacity: Ensure your pump can handle increased system demands.
Upgrade to UL-listed pumps: Improve compliance and reliability.
Consider adding controllers: Modern control systems enhance efficiency and monitoring.
Retest and recalibrate: Verify system performance post-upgrade.

·UL Standard
Flow：50-3000 GPM
Head： 5-20 Bar (72.5-290 psi)
Speed：740-2900 r/min
·Non-UL Standard
Flow：30-9000 GPM
Head： 3-20 Bar (40-300 psi)
Speed：740-2900 r/min

The EDJ model is basically a combination of Electric, Deisel and Jockey pumps. They mainly consist of an electric motor driven end suction pump and a backup pump of a diesel engine driven end suction pump. It is also combined with a jockey pump for maintenance to form a complete skid.
The complete EDJ style skid is assembled with all discharge line fittings and connected to the skid mounted control panel.

Yes, there are regulations and standards set by local, state, and national authorities that dictate the installation, testing, and maintenance of fire pumps. Compliance with these regulations is essential for ensuring the effectiveness of fire protection systems.

Diesel engine fire pump can not be short of a good helper, the rapid development of social science and technology, it has been widely used in the society. The use of diesel engine fire pump is very wide, for the fire has played a very important role, with it can also solve a lot of problems we can not solve before, to bring great help to firefighters, save time and effort is out of efficiency.

The fire pump is usually equipped with a local control cabinet. The control cabinet does not have a transfer control switch for automatic and manual conversion, but the automatic control loop leaves start and stop contacts, which are connected to the fire alarm system control module. In addition, according to the relevant regulations, the system using the bus linkage control should also be set in the fire control room with buttons that can directly start and stop the pump. When the fire alarm system receives the signal of the fire hydrant start pump button, the control module automatically starts the fire pump and collects its feedback signal.

The motor fire pump unit is powered by an electric motor to drive the fire pump and output pressure water for fire fighting. The pump unit is mainly composed of a motor, a water pump, a transmission device, a common base and an instrument table. The starter cabinet is installed near the pump unit for starting the motor.
The electric fire pump set has the advantages of quick start, reliable water diversion, stable operation, high degree of automation, wide range of pressure and flow, etc. It is an advanced and reliable fixed fire-fighting equipment.

The Max Power-2000kw-10KV Split Case EDJ Fire Pump Set is a cutting-edge fire protection solution that combines power, efficiency, and reliability. With a remarkable power output of 2000 kilowatts and a 10-kilovolt system, this fire pump set delivers unmatched water flow capacity and electrical performance. Its advanced Split Case design ensures easy maintenance and optimal performance, making it suitable for a variety of applications. Engineered to exceed industry standards, the Max Power-2000kw-10KV Split Case EDJ Fire Pump Set offers dependable fire protection in the most demanding environments. Invest in this state-of-the-art solution and experience the pinnacle of fire safety technology.

Diesel engine fire pump is also called “engineering diesel engine fire pump set”. The diesel engine fire pump set has the characteristics of good starting characteristics, strong overload capacity, compact and reasonable structure, convenient maintenance, simple and reliable use, etc. The unit is equipped with protection functions such as overspeed, low oil pressure, three start failures, high water temperature, low oil level, and low battery voltage. It can completely meet the fire water supply in various occasions of warehouses, docks, airports, petrochemicals, power plants, liquefied gas stations, textiles and other industrial and mining enterprises.

Flow: 30-9000GPM
Head: 3-20Bar
Speed: 740-2900r/min
Frequency: 50 HZ or 60 HZ
The ED Dual-Power Fire Pump System combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply. In the event of power outages or electrical failures, the diesel engine pump seamlessly takes over, guaranteeing continuous operation of the fire protection system. This dual-power configuration offers both reliability and flexibility, providing comprehensive coverage for fire safety needs.

The fire pump set is a customized 100gpm EDJ fire pump, which is composed of electric pump + diesel pump + jockey pump. It is a standard fire pump set, which is easy to install the fire pump set on site; easy to debug; Wiring electrical connections; less space requirements; all (pump, drive and controller) on one base, etc.

Fire pumps are necessary to maintain adequate water pressure for firefighting, especially in high-rise buildings, large industrial facilities, or areas with insufficient water supply.

The dual power fire pump is composed of a fire water pump, a double shaft extension motor and a diesel engine. One end of the output shaft of the double shaft extension motor is connected to the input shaft of the fire pump, and the other end of the output shaft of the double shaft extension motor is One end of a clutch is connected, and the other end of the clutch is connected with the output shaft of the diesel engine. The fire water pump, the double-shaft extension motor, the clutch and the diesel engine are all fixed on the base. The double shaft extension motor, the clutch and the diesel engine are respectively electrically connected with a control circuit through an action driving circuit. With dual-power fire pumps, there is no need to configure a second fire pump, which reduces floor space and saves manufacturing costs.

For supplying water to automatic fire fighting systems and installations with hydrants. Fire pumps are part of the water supply to a fire sprinkler system and are powered by electricity, diesel or steam. It is used to extinguish fires over a period of time.
The fire pump is equipped with a control panel where you can adjust the flow of water and its power.
It is the most important part of fire protection system safety, in order to ensure the safety of people inside buildings, schools, ministries, hospitals, markets, shops, factories, malls or any infrastructure, a fire pump system must be installed to prevent the fires they enter.
There are different types of fire pumps with different operations and capacities, for example; vertical and horizontal fire pumps powered by electric or diesel.

Electric motor fire pumps are used in various water environments, not only for ordinary water supply but also as a good helper for fire water. The electric motor fire pump is manufactured with good structure and technology, with a wide range of performance, simple operation and long-term use. The electric motor fire pump is aimed at various fire water environments, so the selection should also be based on the actual demand environment, performance parameters, etc.

The EEJ fire pump set consists of two electric pumps + one jockey pump, which is suitable for fire protection occasions such as warehouses, docks, airports, petrochemicals, power plants, liquefied gas, textiles, ships, and oil tankers.

Electric fire pumps have a wide range of uses, of course the most important ones are still used in the fire protection industry, and they are also used in water treatment and environmental protection industries. Among these uses, the firefighting profession uses the most. The fire pump is the advantage of fast water pumping that the firefighting profession has fully utilized. Because most of the work of the firefighting profession is to fight fires, the fire pump has played a great role.

A fire pump system typically includes the pump itself, a driver (usually an electric motor or diesel engine), a controller, and various accessories like suction and discharge piping, check valves, and pressure gauges.

The main reason to have a fire pump is to work with the fire protection system in case the water supply does not have sufficient pressure. High structures or large warehouses that carry large amounts of water require the help of a fire pump. It increases the pressure of the water flowing into the fire suppression system, allowing the system to release the maximum amount of water while extinguishing the fire.

The EJ (Electric pump + Jockey pump) Dual Power Fire Pump System is an innovative and reliable fire protection solution. Combining an electric pump for robust water pressure and flow with a top-quality jockey pump for stable pressure maintenance, this system ensures efficient and timely water supply during fires. With advanced automation, remote monitoring, and energy-saving features, the EJ Dual Power Fire Pump System is a trusted choice for commercial, industrial, and residential applications.

Packaging and delivery

Packaging details: standard export wooden cases or as required delivery detail: within 30 days

Specification

Compact structure, stable performance
Install and maintain conveniently  
Mechanical or packing seal

Application 

Use in fire system water supply, and also suitable for water supply plant, irrigation, drainage pumping plant, electric plant, air conditioning water supply, industry water supply, fire system, shipping industry, oil refining system, mining and other water supplying situations.

The ED Dual-Power Fire Pump System combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply. In the event of power outages or electrical failures, the diesel engine pump seamlessly takes over, guaranteeing continuous operation of the fire protection system. This dual-power configuration offers both reliability and flexibility, providing comprehensive coverage for fire safety needs. With smart controls and automatic switching mechanisms, the transition between electric and diesel engine pumps is seamless, minimizing system downtime. Equipped with advanced safety features, including monitoring and alarm systems, real-time status updates allow for prompt action in case of any irregularities.

Fire pumps are used to pump all kinds of liquids. They are ideal pumps and fire-fighting systems for creating non-leakage, non-polluting civilized workshops and civilized factories. They are often installed on fire trucks, fixed fire-extinguishing systems or other fire-fighting facilities for transportation. Special pumps for liquid extinguishing agents such as water or foam solutions. Fire Pump
Widely used in environmental protection, water treatment, fire protection and other departments.

The fire pump set is composed of a diesel fire pump and an electric fire pump. The pump set is a horizontal, single-suction, single-stage centrifugal pump. It has the characteristics of high efficiency, wide range of performance, safe and stable operation, low noise, long life, convenient installation and maintenance, etc. It is used to transport clear water or other liquids whose physical and chemical properties are similar to water. It can also be used to transport hot water, oil, corrosive or abrasive media by changing the material of the pump’s flow parts, sealing form and adding a cooling system.

Instructions for use of EJ fire pump set:
Altitude: ¡Ü1000m;
Ambient temperature: +5¡æ¡«+40¡æ;
Relative humidity: <= 90%. Scope of application: Equipment suitable for fire protection occasions such as warehouses, docks, airports, petrochemicals, power plants, liquefied gas, textiles, ships, oil tankers, etc.

This fire pump set uses Cummins diesel engine and ISO pump. The EDJ Diesel Engine Fire Pump System is a powerful and reliable firefighting equipment designed for fire suppression and emergency rescue operations. It boasts high-performance capabilities in water extraction and pressure delivery, enabling rapid supply of large volumes of water. The system operates independently, ensuring its reliability even in challenging situations. With its lightweight and portable design, coupled with versatile functionality, the EDJ Diesel Engine Fire Pump System is suitable for various scenarios. Whether you are part of a fire department or an industrial enterprise, the EDJ Diesel Engine Fire Pump System is your indispensable rescue partner.

The biggest difference between the diesel engine fire pump and the electric water pump is that it has its own independent power supply system, which can ensure the normal operation of the project without power or power supply. Its role is self-evident, and it can be said to be a great helper in fire emergency .

The fire pump set is composed of electric pump + diesel pump + jockey pump. It is a set of 750gpm@90m pump set, which is manufactured in strict accordance with the NFPA20 standard.
The fire pump adopts XA pump, the product combines the advantages of similar products at home and abroad, and adopts the excellent hydraulic model design. Therefore, its excellent hydraulic performance and structural characteristics ensure that users can effectively reduce the operating cost of the pump in various applications. The fire pump group of this group is not affected by the mains. When the electric pump fails, the diesel pump will automatically start to operate.

1.Flow：30-9000 GPM
2.Head： 3-20 Bar 40-300 psi
3.Power：Diesel & Electric Pump:1.5-710kw Jockey Pump:0.55-160kw
4.Speed：740-2900 r/min
The EDJ Diesel Engine Fire Pump System is a powerful and reliable firefighting equipment designed for fire suppression and emergency rescue operations. It boasts high-performance capabilities in water extraction and pressure delivery, enabling rapid supply of large volumes of water. The system operates independently, ensuring its reliability even in challenging situations.