Outdoor fire pump set

Flow: 30-9000GPM
Head: 3-20Bar
Speed: 740-2900r/min
Frequency: 50 HZ or 60 HZ
The ED Dual-Power Fire Pump System combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply. In the event of power outages or electrical failures, the diesel engine pump seamlessly takes over, guaranteeing continuous operation of the fire protection system. This dual-power configuration offers both reliability and flexibility, providing comprehensive coverage for fire safety needs.

Fire pump set test mainly tests pressure and flow. In all pump products, pressure and flow and two extremely important parameters. Pressure determines the pumping height or water delivery height of the pump, and flow determines the hourly water output of the pump. In addition. Product power and voltage, as well as environmental testing is also essential.

100gpm5bar ED fire pump ready to Africa

Flow: 30-9000GPM
Head: 3-20Bar
Speed: 740-2900r/min
Frequency: 50 HZ or 60 HZ

The ED Fire Pump Set combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply.

ED small fire pump set (referred to as ED small fire complete set of water supply equipment) refers to a highly integrated electromechanical system with a flow rate of less than 100GPM and composed of electric centrifugal pumps, multi-stage centrifugal pumps (booster pump sets), diesel engine centrifugal pumps, pressure limiting protection Device (safety valve), valve fittings, control system, pressure sensor system, waterless protection device, backflow preventer, soft joint, bypass pipeline, common base, filter, etc. It is a fire-fighting water supply equipment that continuously supplies water to the fire-fighting pipe network at a preset pressure.

Mechanical seals are commonly used on fire pumps to ensure reliable and long-lasting operation. These seals are designed to create a tight, reliable seal between the pump shafts, and the fire pump’s motor. Mechanical seals are typically composed of stationary and rotating components that move against each other with minimal friction, to form a mechanical seal that can withstand the stresses of the fire pump’s operation. In addition to preventing leaks, mechanical seals can help improve pump efficiency, reduce wear and tear on motor components, and increase the life of the fire pump.

The EEJ Fire Pump System is an innovative solution designed to enhance fire safety in various settings. With exceptional performance and efficiency, the EEJ Fire Pump System delivers high pressure and large flow capacity, enabling rapid and effective fire suppression. Its intelligent features, including real-time monitoring and remote control capabilities, contribute to the system’s reliability and ease of operation. Overall, the EEJ Fire Pump System is a reliable choice for safeguarding lives and properties, making it an ideal fire protection solution for commercial buildings, industrial facilities, and residential areas.

The fire pumps used in diesel engine fire pump sets can be IS series single-stage type, S, D type series segmental multi-stage type produced by our company. The diesel engines used in this series of equipment are domestic or imported high-quality products, which have the characteristics of good starting characteristics, strong overload capacity, compact structure, convenient maintenance, simple use, and high degree of automation. It is an advanced and reliable fire-fighting equipment.

Electric pump + diesel pump + joceky pump
The three pumps are automatically started and stopped. When the joceky pump detects that the electric pump cannot operate normally, the diesel engine pump will start automatically. Can also be used, the fire pump set is widely used in various emergency firefighting occasions.

– Reliability in Extreme Conditions: Ensuring systems can operate reliably in extreme and isolated conditions.
– Efficient Water Supply Management: Implementing solutions that manage water supply efficiently in remote areas.
– Minimal Maintenance Requirements: Designing systems with minimal maintenance needs to reduce the reliance on remote support.
– Compliance with Remote Area Safety Standards: Adhering to fire safety regulations specific to remote and isolated locations.

Fire Pump Packages
Fire pump package comprises a combination of electric motor driven pump, diesel engine driven and electric motor driven jockey pumps that supply for fire suppression systems.
Fire pump package is required to comply with Local Civil Defense Authority regulations and International Codes of Practice e.g. National Fire Protection Association (NFPA).

Types of pumps used for fire service include: end suction, horizontal split case, vertical split case, vertical inline and vertical turbines.

·UL Standard
Flow：50-3000 GPM
Head： 5-20 Bar (72.5-290 psi)
Speed：740-2900 r/min
·Non-UL Standard
Flow：30-9000 GPM
Head： 3-20 Bar (40-300 psi)
Speed：740-2900 r/min

Flow: 120GPM≤Q≤1500GPM
Rated pressure: ＜150m
Speed: 2950 to 3550 RPM
Frequency: 50Hz or 60Hz

Fire pumps are rated based on their capacity and pressure performance. The two key ratings are:

Gallons Per Minute (GPM): This rating indicates the pump’s flow capacity and how much water it can deliver per minute. It is essential to ensure that the fire pump can meet the specific flow requirements of the fire protection system.

Pressure (PSI): The pressure rating specifies the force with which the pump can deliver water. Sufficient pressure is critical for effectively propelling water through the fire sprinklers and hoses.

Understanding these ratings is vital when selecting a fire pump for a facility, as it ensures that the pump can meet the specific needs of the fire protection system.

EDJ fire pump after packaged
250gpm 10bar EDJ fore pump set

This is a set of EDJ fire pump set, which consists of electric pump + diesel pump + jockey pump. The three pumps are automatically started and stopped. When the joceky pump detects that the electric pump cannot operate normally, the diesel engine pump will start automatically. Can also be used, the fire pump set is widely used in various emergency firefighting occasions.

EDJ Fire Pump Range：
Flow:5-400L/s
Head:3-20Bar
Material:HT200, SS304, Bronze
Caliber:65-350mm
Pressure:0.3~1.5MPa
Speed:740-2900r/min

This equipment is a customized EEJ fire pump set which can meet 500GPM@80m. The duty pump and standby pump are XA series pump.

The diesel engine fire pump has automatic, manual and fault self-checking functions. It can monitor the working state of the whole process, restore the function of failure start, automatic pre-lubrication and automatic restart of preheating, so that the equipment start-up is safer and more reliable. It has the functions of central control room remote control, remote control and field bus connection. The battery is fully automatic floating charge (constant current, constant voltage, trickle charge) mode to ensure that the battery is in a standby state at any time. Diesel engine fire pump is easy to use, equipped with remote instrument and instrument, which can be connected to the control center as needed, easy to install and use, and easy to maintain.

·UL Standard
Flow：50-3000 GPM
Head： 5-20 Bar (72.5-290 psi)
Speed：740-2900 r/min
·Non-UL Standard
Flow：30-9000 GPM
Head： 3-20 Bar (40-300 psi)
Speed：740-2900 r/min

One way to choose a diesel generator set as a backup power source for fire fighting backup power is because in fire fighting, two power supplies are required, which can be two power plants and two transformers, or one mains and one diesel generator set. Meet the requirements of fire backup power.

Early detection of fire pump issues is crucial for preventing critical system failures. This article explores the functionalities and benefits of fire pump alarms and monitoring systems in detail. It explains how these systems provide real-time data on the status and performance of fire pumps, enabling early warning of potential problems. By embracing these technologies, facility managers can ensure continuous oversight and timely intervention.

Diesel engine fire pump can be used in fire water supply in warehouses, docks, airports and other occasions. We usually choose the appropriate diesel engine fire pump model and application according to the head, flow, power, medium properties, and required materials provided by the user. In order to avoid mistakes, the loss caused by the installation environment will be comprehensively considered to ensure stable and reliable efficiency.

·UL Standard
Flow：50-3000 GPM
Head： 5-20 Bar (72.5-290 psi)
Speed：740-2900 r/min
·Non-UL Standard
Flow：30-9000 GPM
Head： 3-20 Bar (40-300 psi)
Speed：740-2900 r/min

The ED Dual-Power Fire Pump System combines electric and diesel engine pumps to ensure uninterrupted fire protection and a reliable water supply. In the event of power outages or electrical failures, the diesel engine pump seamlessly takes over, guaranteeing continuous operation of the fire protection system. This dual-power configuration offers both reliability and flexibility, providing comprehensive coverage for fire safety needs. With smart controls and automatic switching mechanisms, the transition between electric and diesel engine pumps is seamless, minimizing system downtime. Equipped with advanced safety features, including monitoring and alarm systems, real-time status updates allow for prompt action in case of any irregularities.

The Fire Pressure Stabilization Equipment, coupled with the CDL Vertical Multistage Fire Pump, offers a comprehensive solution to elevate fire safety measures. This powerful combination ensures a consistent water pressure for effective fire suppression. By incorporating pressure stabilization technology, this system guarantees an uninterrupted fire water supply, efficient water distribution, and reliable operation of fire hydrants and sprinkler systems. With advanced infrastructure and the ability to maximize firefighting capabilities, this configuration significantly enhances overall fire safety standards. Investing in fire pressure stabilization equipment is a proactive step towards ensuring superior fire protection and providing peace of mind in critical situations.

After receiving the fire/pipe network pressure/power failure/other start signals, the diesel engine fire pump can automatically start and enter full load operation within 5 seconds. The battery can be automatically charged by the main power supply or the diesel charging motor to ensure the smooth start of the equipment; automatic alarm protection for low oil pressure, high water temperature and other faults of the diesel engine, overspeed alarm and shutdown; the diesel engine fire pump is in a hot engine standby state to ensure emergency work. The diesel engine fire pump adopts the direct connection technology between the diesel engine and the water pump. Through the elastic coupling, the failure points are reduced, the start-up time of the unit is greatly shortened, and the reliability and emergency performance of the unit are improved.

Factors include the building size, height, occupancy type, local fire codes, water supply source, and the required water flow and pressure. A thorough hydraulic analysis is typically performed to determine the appropriate pump size and type.

Electric fire pumps can be located inside the building. Office buildings and apartments are often equipped with electric fire pumps. In addition, upper floors sometimes install an additional electric fire pump above ground or basement to increase water pressure.