engine fire pump

A diesel engine self-priming pump with high efficiency is a type of pump that combines the advantages of a diesel engine power source, self-priming capability, and a design that maximizes pumping efficiency. This type of pump is commonly used in various applications where a reliable and efficient water transfer is required, particularly in scenarios where the pump needs to handle large volumes of water and deal with air or gas entrained in the fluid.

Split case diesel engine fire pump combines the features of a split case fire pump with the reliability and independence of a diesel engine-driven system. This configuration is commonly used in applications where a dependable source of power is crucial to maintain fire protection capabilities during power outages or in remote locations. Here are the key features of a split case diesel engine fire pump:

The frequency of running a fire pump, also known as a “fire pump churn test” or “fire pump test,” is typically recommended on a regular basis to ensure that the pump is in good working condition and can perform its critical role in fire protection when needed. The frequency of these tests can vary depending on the specific regulations, codes, and guidelines of the local jurisdiction or the recommendations of the equipment manufacturer. Here are some general guidelines:

Environmental and Working Conditions
Ambient temperature:
Ambient temperature range 4℃-40℃.
Working to improve the ambient temperature every 5℃, its power decreased by 1%(to 25℃ as the base);
Altitude:
Reference elevation 91.4m, the reference atmospheric pressure is 100KPa;
If the work to an altitude of over 1000m, reference should be corrected GB1105 1-1987 diesel engine power, you can consult the specific technical department;
Relative humidity ≤80% (20℃), outdoor allow 90% (when installed outdoors in the order presented, you can choose to configure the outdoor structure, protection class IP55).

The diesel engine fire pump is a kind of electromechanical integration equipment which can be driven directly by the fire pump and can start and finish the water supply in a short time. It is suitable for agricultural irrigation, rescue and relief, smelting, aircraft depot, petrochemical oil depot, liquefied gas station, textile and other fire-fighting water supply occasions, especially in the case of power supply cannot be satisfied, the choice of diesel-driven pumps is a reliable and guaranteed equipment choice.

Application
Hotels, hospitals, gymnasium and other public places;
Chemical, oil refining, metallurgy, energy, medicine and military and other enterprises;
Shopping malls, similar to Wanda complex;
Office buildings, high-end residential buildings;

Diesel engine fire pump is suitable for unattended fire water supply system. Diesel engine fire pump is mainly used for fire hydrant fire extinguishing, automatic sprinkler fire extinguishing and other fire fighting systems in fixed fire fighting systems such as industrial and mining enterprises, engineering construction, and high-rise buildings. The clean water and chemical properties of the particles are similar to the medium of water, and can also be used in life, production and shared water supply systems and buildings, municipal water supply and drainage, docks, offshore platforms and other occasions without power supply.

ISW series horizontal single-stage single-suction centrifugal pump is a new generation of energy saving, environment friendly horizontal centrifugal pump researched and developed by our company, which absorbs advanced technology of similar products abroad and adopts domestic general performance parameters of centrifugal pumps.

Diesel fire water pumps are usually used as backup facilities. Therefore, only when a signal comes, and the electric water pump fails or the power supply is cut off, it will automatically start. When it has an ultra-low pressure pump starting device, its matching electric water pump control cabinet should also have an ultra-low pressure pump starting device, and the lower limit of the pump should have a certain pressure difference. Of course, we can also design a control system according to customer requirements.