fire pumps

This is a set of EDJ fire pump set, which consists of electric pump + diesel pump + jockey pump. The three pumps are automatically started and stopped. When the joceky pump detects that the electric pump cannot operate normally, the diesel engine pump will start automatically. Can also be used, the fire pump set is widely used in various emergency firefighting occasions.

1. Application Scope
Equipment for warehouses, docks, airports, petrochemical, power plants, liquefied gas, textiles, ships, oil tankers and other occasions of a fire service.
2. Using Instruction
Altitude ≤ 1000m;
Ambient temperature: +5 °C ~ +40 °C;
Relative humidity: <= 90%.

Electric horizontal multistage pump use for main pump, and standby pump also same, but use diesel engine driven.

XA bare pump with below Models for packing
XA100/26
XA80/26
XA65/32
XA50/32

Stationary Pumps for Fire Protection: The diagram illustrates for a diesel-driven horizontal End suction fire pump assembly, electric fire pump as duty, a diesel drive pump as the backup.

1. The pump is a vertical structure, the inlet and outlet diameters are the same, and they are located on the same center line. It can be installed in the pipeline like a valve. The appearance is compact and beautiful, the floor space is small, and the construction investment is low. Can be used outdoors.
2. The impeller is directly installed on the elongated shaft of the motor, the axial dimension is short, the structure is compact, and the pump and motor bearings are reasonably arranged, which can effectively balance the radial and axial loads generated by the operation of the pump, thereby ensuring the smooth operation of the pump. Low vibration and low noise.
3. The shaft seal adopts mechanical seal or mechanical seal combination, adopts imported titanium alloy sealing ring, medium-sized high temperature resistant mechanical seal and hard alloy material, wear-resistant seal, which can effectively prolong the service life of mechanical seal.
4. Easy installation and maintenance, no need to dismantle the pipeline system, just remove the pump joint seat nut to extract all the rotor parts.
5. The series and parallel operation modes of pumps can be adopted according to the requirements of use, that is, the needs of flow and head.
6. The vertical and horizontal installation of the pump can be adopted according to the requirements of the pipeline arrangement.

The equipment is suitable for fire water supply and emergency water supply in various occasions such as warehouses, docks, airports, petroleum, chemical, factories, power plants, liquefied gas, textiles, ships, cruise ships, etc.

Since its establishment 19 years ago, the company has continuously developed new products, committed to the principle of high efficiency, energy saving, convenience and durability, and obtained various patents and applications to ensure the quality of customers’ products. Integrating production, installation, testing, packaging and transportation, the omni-directional fire protection production system makes every customer feel at ease and makes all customers full of confidence.

We have motor and pump material in stock

Diesel engine fire pump product overview: The fire pump used in the diesel engine fire pump complete set can be the IS series single-stage type and D-type series segment multi-stage type produced by our company. The diesel water pumps used in this series of equipment are made of domestic or imported high-quality products. They have the characteristics of good starting characteristics, strong overload capacity, compact structure, convenient maintenance, simple use and high degree of automation. They are advanced and reliable fire fighting equipment.

Scope of application of fire pump:
Equipment for warehouses, docks, airports, petrochemical, power plants, liquefied gas, textiles, ships, oil tankers and other occasions of a fire service.

Electric motor fire pumps are used in various water environments, not only for ordinary water supply but also as a good helper for fire water. The electric motor fire pump is manufactured with good structure and technology, with a wide range of performance, simple operation and long-term use. The electric motor fire pump is aimed at various fire water environments, so the selection should also be based on the actual demand environment, performance parameters, etc.

The advantage of the multi-stage pump is in the head, which has the characteristics of small flow and high head. The multi-stage fire pump has two or more impellers, which can achieve a larger head at the same flow rate. Generally, they can be used as industrial pumps, domestic pumps and fire pumps.

XA Bare Shaft Pump under painting
XA100/32,XA100/20,XA100/26

Middle open pump (middle open cycle), also known as single-stage double suction centrifugal pump, is mainly characterized by large flow of conveying medium.

Operating principle of the split pump: the impeller is installed in the pump shell and fastened on the pump shaft, which is directly driven by the motor. The center of the pump housing is connected with a liquid suction pipe. The liquid enters the pump through the bottom valve and the suction pipe. The liquid discharge port on the pump casing is connected with the discharge pipe. When the speed of the pump is constant, its head and flow are related to the impeller diameter.

1. Fire hydrant fire extinguishing system and automatic sprinkler fire extinguishing system in fixed fire protection systems of various enterprises and institutions, engineering construction, high-rise buildings, etc.
2. High-rise building partition fire water system, fire and living, production and shared water supply system and buildings, municipal, industrial and mining, boiler water supply and other occasions.
3. Fire-fighting system pressurized water supply, water supply plants, irrigation, drainage pumping stations, power stations, air-conditioning circulating water, industrial water supply systems, fire-fighting systems, shipping industry, oil refining systems, mining and other liquid transportation.
4. Fire water supply and emergency water supply in docks, warehouses, airports, petroleum, chemical, power plants, liquefied gas, textiles, ships, oil tankers, etc.

Portable pump, mostly used for irrigation and port dock pumping water. Is a small diesel pump, now many countries began to use a large range of portable diesel pump, because the diesel pump is not affected by the power system, can work in an electric environment, and portable diesel pump is easy to install and move, is favored by the majority of customers.

XBD series fire pump sets are mainly used for fire hydrant fire extinguishing systems and automatic sprinkler fire extinguishing systems in fixed fire protection systems of various enterprises, institutions, engineering construction, high-rise buildings, etc. The chemical properties are similar to the medium of water, and it can also be used for fire protection, living, production, public water supply systems and buildings, municipal water supply and drainage, etc.

EEDJ Fire Pump Package ,The equipment is designed to have 2 electric pumps. one duty and one standby and one diesel pump stand by function. The main pump runs normally, and the standby pump starts automatically after the main pump fault . The Jockey pump will start and stop based on the pipe pressure, Control panel site start.

1、 Star delta startup mode
2、 Auto coupling step-down startup mode
3、 Soft start mode
4、 Direct start mode

End suction centrifugal water pump is an energy-saving pump designed by teamwork in the whole nation, it is improved on a basis on model BA, B and other single-stage water centrifugal pump.

Product Overview
Product Introduction of ISG, ISW single-stage single-centrifugal pump
ISG series vertical single-stage single-suction centrifugal pump is a new generation of energy saving, environment friendly vertical centrifugal pump researched and developed by our company, which absorbs advanced technology of similar products abroad and adopts domestic general performance parameters of centrifugal pumps. In addition, according to different operation temperatures and mediums, we developed the hot-water pump (IRG), corrosion-resistant chemical pump (IHG) and oil pump (YG). This pump enjoys excellent performance, good reliability, long operation life, reasonable construction and nice appearance, which is outstanding in the industry.

Product Overview
Product Introduction of EDJ Fire Pump System
1. Electric pump, can use single stage pump, horizontal split case pump, end suction pump, multistage pump, material can be cast iron, stainless steel, and bronze impeller 
2. Diesel engine pump, with capacity and head equal to electric pump, with fuel tank, water tank，fan, control box
3. Jockey pump, horizontal or vertical, capacity will be small, but head should be higher than electric and diesel engine pump
4. Control panel: Auto Control of electric pump, diesel engine pump and Jockey Pump with overload, over current protection。
5. Accessories: check valve, gate valve, pressure vessel, generally 0.6mpa, 1.0mpa, 1.6mpa, Pressure Gauge, Pressure Sensor, Common Pipe for Suction and Discharge, Flexible Joints and Flanges, Common Base plant

The fire pump unit can be classified according to the following rules:
1 according to the form of power source, it can be divided into:
A) diesel engine fire pump unit
Motor fire pump unit
C) gas turbine fire pump unit
D) gasoline engine fire pump unit
(2) it can be divided into:
A) water supply fire pump unit
Stabilized pressure fire pump unit
C) hand lift motorized fire pump unit
3. According to the auxiliary characteristics of the pump unit, it can be divided into:
A) common fire pump unit
Deep well fire pump unit
C) submersible fire pump unit
The above is the basic classification, but various types can be combined with each other, such as medium and low pressure fire pumps, high and low pressure vehicle fire pumps, ordinary fire pump sets, electric submersible fire pump sets, etc

1. Better is a professional fire pump manufacturer with 17 years of industry experience
2. Professional sales team and R&D team, strong technical skills, self-produced control system
3. The motor is self-produced and can produce 50/60HZ

The pressure stabilizer pump is used in conjunction with the air pressure tank, which is generally a complete set of equipment. Simply speaking, when the water in the air pressure tank decreases (that is, when the user uses it), the gas pressure in the tank decreases. To draw water, it can meet the user’s use pressure and the storage pressure in the tank at the same time. When the storage pressure in the tank reaches the standard, stop the pump and wait for the user to use it.

The hot water pump is also a hot water pump product optimized on the basis of the ISG and ISW centrifugal pump series, especially the IRG hot water circulating pump has the largest consumption, because the pump adopts the vertical installation of the motor on the upper part, and the connection between the pump and the motor. There is also a short bracket in between, which will not cause the water in the motor to burn out the motor due to the leakage of the mechanical seal, and it can also be designed as a mechanical seal on the basis of the IRG hot water pump. The maximum temperature of high temperature pump products can reach 240 ¡ã C.

XBD series fire pump set is mainly used for fire hydrant fire extinguishing system, automatic sprinkler fire extinguishing system, etc. in fixed fire fighting systems of various enterprises and institutions, engineering construction, high-rise buildings, etc. The chemical properties are similar to the medium of water, and it can also be used for fire protection, living, production, public water supply systems and buildings, municipal water supply and drainage, etc.

EDJ fire pump set consists of diesel engine fire pump, electric pump set and stabilized pump to form an automatic fire water supply system

EEJ Fire pummp set
Fire pump system is made of E+E+J
Operation: 1 Duty (electric) + 1 standby (electric) + 1 Jockey
Capacity: 100, 150, 200, 300, 400, 500, 750, 1000…GPM with pressure 4, 5, 6, 8, 10… Bar.
Pressure vessel 25, 50, 75, 100…liters, pressure will be 0.6mpa, 1.0mpa, 1.6mpa, select according to pump head.